避免跌落：如果受到强烈碰撞或振动，引闪器可能会发生故障。
保持干燥：本产品是非防水产品，如果将其浸入水中或放置于高湿度的环境中将可能发生故
障 。内 部 构 造 生 锈 可 能 会 导 致 无 法 修 理 。
避免温度骤变，诸如在寒冷天进出温暖的大楼将可能会使引闪器内部结露。为避免结露，请将
引闪器事先装入手提袋或塑料包内，以防温度突变。
远离强磁场：无线电广播发射机等设备产生的强静电或强磁场可能会干扰本产品正常工作。
外部环境 2.4G 信号干扰 ( 如无线基站、2.4Gwi 路由、蓝牙设备等 )
请调节引闪器的频道 CH 设置 ( 建议 +10) 找到无干扰的频道来工作，或者在工作时关闭其
他 2.4G 设备。
请确认闪光灯是否已经回电或者回电速度已经跟上连拍速度 ( 闪光灯就绪指示灯已经亮
起 )，并且没有处于过热保护或者其他异常状态中。
请下调闪光灯的档位，如是 TTL 模式可以尝试改为 M 模式 (TTL 模式下需要预闪一次 )。
是否引闪器和闪光灯距离太近 ( 距离 <0.5m)
请在引闪器上打开“近距离无线模式”: 设置引闪距离为 0-30m。
是否引闪器和接收端设备在低电状态
请及时充电或更换电池，让引闪器和接收器处于有电状态。
This product is a professional photographic equipment, to be operated by professional
personnel only.
The following basic safety precautions must be followed when using this product:
All transport protective materials and packaging on the product must be removed before use.
Carefully read and fully understand the instruction manual before use and strictly
follow the safety instructions.
Dot not use damaged equipment or accessories. Allow professional repair
technicians to inspect and confirm normal operation before continuing use after
repairs.
Please disconnect the power when not in use.
This device is not waterproof. Keep it dry and avoid immersing it in water or other
liquids. It should be installed in a ventilated and dry location and avoid using in rainy,
humid, dusty, or overheated environments. Do not place items above the device or
allow liquids to flow into it to prevent danger.
Do not disassemble without authorization. If the product malfunctions, it must be
inspected and repaired by our company or authorized repair personnel.
Do not place the device near alcohol, gasoline, or other flammable volatile solvents or
gases such as methane and ethane.
Do not use or store this device in potentially explosive environments.
Clean gently with a dry cloth. Do not use a wet cloth as it may damage the device.
This instruction manual is based on rigorous testing. Changes in design and
specifications are subject to change without notice. Check official website for latest
instruction manual and product updates.
31 32
To Next Page
Loading...
