Godox X1T User Manual

FLASH TRIGGER QUICK START GUIDE
A quick start guide for connecting the Godox V860II flash with the Godox X1T trigger.
Turn both switches on the side of the trigger on.
Can be changed to
match the settings on
your camera, but not
always necessary.
The flash & trigger
communicate via radio
waves, so these are
the same channels youʼd
see on a walkie talkie
or something similiar.
1
channel group mode
https://www.youtube.com/watch?v=QdqOgRuRiuo&list=PLRcCi5SRb3EVsE4ONaFz7QOAHKlhbd4y0&index=4 Hereʼs a quick video to help you get started.

Godox X1T Specifications

General

Type	Wireless Flash Trigger
Frequency	2.4 GHz
Range	100m
Channels	32
Groups	5
Power Supply	2 x AA batteries
HSS	Yes
Sync Speed	1/8000s
Dimensions	72 x 75 x 52 mm
Compatibility	Canon, Nikon, Sony, Fujifilm, Olympus, Panasonic
Flash Modes	Manual, Multi, TTL
FEC	±3 stops in 1/3 stop increments
Firmware Upgrade	Yes

Summary

Godox X1T Trigger Overview

Trigger Controls and Display

Explains the function of channel, group, and mode indicators on the trigger display.

Godox V860II Flash Setup

Slave Mode and Channel Matching

Guides on setting the flash to slave mode and matching its channel with the trigger.

Multi Mode Configuration

Details on using multi mode, setting flash count, and shutter speed requirements.

Alternative Flash Setup: YN560IV

Channel Synchronization and Slave Mode

Instructions for matching channels and setting the YN560IV flash to slave mode (S1).

Compatibility and Troubleshooting

Addresses potential incompatibility issues with the YN560IV and provides troubleshooting steps.