Why is my Goldair Blender food burnt and stuck to the bottom?
This issue may arise from using ingredients high in sugar or starch that come into contact with the unit's bottom. Consider using ingredients with lower sugar/starch content. Alternatively, add the ingredients after the liquid and place them inside the filter. It can also happen if there is too much food and not enough liquid, so decrease the solid to liquid ratio.
What to do if my Goldair Blender stops mid-program?
Your Goldair Blender might stop mid-program due to several reasons. The lid may be loose, so tighten it. The liquid level could be too low because of evaporation during cooking, in that case, check and refill the liquid level. Alternatively, the liquid level might be over the maximum, so reduce the liquid amount. Finally, ensure the jug is properly connected with the base.
What to do if my Goldair FHSM200 Blender is not working and beeping?
If your Goldair Blender isn't working and is beeping, it could be due to a few reasons. Ensure the jug and the lid are correctly fitted to the base. Also, check if there is enough liquid in the jug, and add more if needed. Finally, clean any spills around the over-flow sensor.
Why is my Goldair Blender soup not hot and the cooking cycle finished early?
If your soup is not hot and the cooking cycle finished early, it could be because there was too much liquid in the jug, so reduce the amount of liquid. It may also be that movement of the soup during cooking reached the upper overflow sensor and stopped the unit, so avoid excessive movement of the soup during cooking.
Why is food still too large after the cycle is complete in my Goldair FHSM200?
If food remains too large after the cycle, it might be because the pieces were too large initially, in that case use the BLEND function after the cooking program. Ensure that you selected the correct function. Also, verify that you added sufficient water.
How to prevent ingredients from being hard after cooking cycle in Goldair Blender?
To prevent ingredients from being hard after the cooking cycle, chop the ingredients into small pieces before adding. Ensure you are using the correct soup cycle. Check the water/food amount and clean the filter if needed. Some foods require longer cooking, so select one of the heating functions to keep the unit working until food is fully cooked.
Essential safety guidelines for product handling and use to ensure user safety.
Prohibited actions and environments for using the appliance to prevent hazards.
Explanation of built-in safety features like interlocking lid and sensors.
How to choose and initiate different cooking or blending programs.
Instructions for preparing chunky and smooth soups, including ingredient tips.
Procedures for using the steam and boil functions for cooking food.
Identifies causes for the unit failing to start or emitting beeping sounds.
Addresses issues where the cooking or blending process halts unexpectedly.
To Next Page
General