Do you have a question about the Golden GB-106XR Buzzaround Lite and is the answer not in the manual?
Lean forward, drive straight up/down, avoid hazardous surfaces, restart carefully.
Always drive forward down inclines; never reverse.
Avoid sharp turns to prevent tipping; steer wide arcs, reduce speed. Emergency stop by removing key. Never operate on snow/ice. Use seat backrest or tiller for support.
Pre-selects maximum speed; turn counterclockwise for slowest, clockwise for fastest.
Insert key to turn scooter on/off; green LED indicates power. Remove key before mounting/dismounting.
Controls speed and direction via wig-wag lever; use thumbs on F/R levers.
Use right thumb on 'F' lever to move forward; increase pressure for speed; release to stop.
Use left thumb on 'R' lever to move in reverse; increase pressure for speed; release to stop.
Loosen knob to adjust tiller angle for comfortable driving position, then tighten knob to secure.
Loosen rear knobs to slide armrests in/out, then tighten. Max width 24".
Loosen rear knobs to slide armrests in/out, then tighten. Max width 24".
Remove seat, loosen pin/bolt on seat post, adjust height, reinsert pin/bolt securely.
Ensure seat is locked forward, position seat for mounting, use rotate lever, fasten lap belt.
Ensure seat is locked forward, position seat for mounting, use rotate lever, fasten lap belt.
Sit safely, set slowest speed, insert key, power on, place hands on grips, use thumb levers for forward/reverse, accelerate gently.
Turn tiller with handgrips to steer right/left. Maintain clearance for rear wheels.
Turn tiller with handgrips to steer right/left. Maintain clearance for rear wheels.
Ensure key is off. Plug charger into pack and outlet. Red LED indicates charging, green indicates full charge. Do not cover charger.
Ensure key is off. Plug charger into pack and outlet. Red LED indicates charging, green indicates full charge. Do not cover charger.
Covers structural frame components like frame, welds, tiller frame, front fork, seat post.
Covers structural frame components like frame, welds, tiller frame, front fork, seat post.
Covers drivetrain (transaxle, motor/brake) and electronics (controller, charger, dash, potentiometers, harness).
Covers bearings, bushings, seat swivel, armrests, rubber components, plastic components.