Goldline aqua trol User Manual

Above-Ground Pool Automation
by
888-921-POOL
www.goldlinecontrols.com
Questions?
Refer to www.goldlinecontrols.com for latest manual
revisions, additional information and helpful service. Or, you
may visit your local Authorized Aqua Trol
®
Dealer or call 888-
921-POOL (7665) for assistance.
ELECTROLYTIC CHLORINE GENERATOR
BASIC POOL MAINTENANCE REQUIREMENTS
North Kingstown, RI 02852 USA
092016G
WEEKLY
MONTHLY
QUARTERLY
Free Chlorine 1.0 - 3.0 ppm Turn output dial up to increase,
pH 7.2 - 7.6
down to decrease -OR- increase
Too low - add soda ash.
or decrease pump filtration time.
Too high - add muriatic acid
Alkalinity 80 - 120 ppm
Salt 2700 - 3400 ppm Add salt as required to increase.
Add baking soda to increase.
Stabilizer 60 - 80 ppm Add cyanuric acid to increase.
Calcium 200 - 400 ppm Add calcium to increase.
Electrolytic Cell inspect & clean Refer to section in manual.
TEST IDEAL RANGE ADJUSTMENT REQUIRED
Drain and add water to decrease.
A
dd acid as required to decrease.
LD
C
G
LINE
ON
T
ROLS
LD
C
G
LINE
ON
T
ROLS
Aqua TrolAqua Trol
Aqua TrolAqua Trol
Aqua Trol
®

Goldline aqua trol Specifications

General

Frequency	50/60 Hz
Power Supply	120/240 VAC
Output	Up to 40, 000 gallons
Control Method	Automatic
Water Flow Rate	20-80 GPM
Salinity Range	4500 ppm
Pool Size	Up to 40, 000 gallons (depending on model)
Display	Digital Display
Type	Salt Chlorine Generator

Summary

Safety Instructions

Operating the Aqua Trol System

Water Chemistry Guidelines

Recommended Water Chemistry Levels

Lists ideal ranges for salt, chlorine, pH, alkalinity, and stabilizer.

Understanding Saturation Index

Salt Level Management

Determining Salt Requirements

Control System Features

Timer and Manual Operation

Main Switch Modes

System Status and Operation

Troubleshooting LED Indicators

Optimizing Chlorine Production

Identifies factors influencing chlorine generation and how to adjust them.

System Maintenance

Electrolytic Cell Care

Covers inspection, cleaning, and mild acid washing of the electrolytic cell.

Installation Procedures

Preparing Pool Water for Installation

Mounting the Aqua Trol Control

Gives guidelines for physically mounting the control unit.

Plumbing Connections

Hose/Pipe Plumbing (-HP Option)

Return Jet Plumbing (-RJ Option)

Electrical Wiring

Input Power Connection

Covers connecting the Aqua Trol to a 120 VAC GFCI power source.

Troubleshooting Guide

Diagnostic Display Information

Explains the sequential displays on the LCD for diagnostics.

Addressing Common Problems

Provides solutions for issues like "Power" LED not on or filter pump not running.

Advanced Troubleshooting

LED Fault Indicator Solutions

Details troubleshooting steps for specific LED fault indicators.

Chlorine Residual Troubleshooting

Identifies causes for low or no free chlorine residual and remedies.