Output
After activating the alarm output, the indoor station emits a signal when the
doorbell rings at the door station. If you connect an electronic chime to the NO and
COM connections of the indoor station, it will ring in addition to the indoor station.
Alarm mode
Set the on/off status of the range for different modes. The area mode can only be
set in unsharp status.
Step 1 Tap Settings.
Step 2 Select the mode.
• At home:
An arming mode that allows you to activate the system when you are within the
range of the alarm system. For example, indoor detectors remain deactivated.
• Absent:
Activate the system when you leave the alarm system area.
• Sleep mode:
An alarm mode that allows you to activate the system during sleeping hours. For
example, detectors in the bedrooms remain switched off.
• User-defined:
Activate the system according to your individual needs.
Step 3 Select the arming mode that you want to use in the
configure the tabs.
Step 4 Switch individual areas to ON or OFF to add them to the arming mode.
Several areas can be added to an arming mode at the same time, while an area
can be assigned to different modes.
To Next Page
Loading...