GoNetspeed G-010G-A ONT User Manual (English)

To Next Page

GoNetspeed ONT Troubleshooting and Illustrations

Use this document to become familiar with the Nokia G-010G-A ONT (optical network

termination). GoNetspeed uses this ONT to provide Internet service to your home. The

ONT may also be placed inside of a wall bracket (see illustration below) and mounted to

the wall.

G-010G-A ONT Light Descriptions

POWER: The topmost light on the ONT pictured above is the power light. This light will

be either off, on (green), or red (Hardware startup has failed or self-test has failed). If the

power light is red, power-cycle the ONT. If it is still red then open a trouble ticket.

PON: The second light from the top on the ONT pictured above is the PON light. This

light is lit when the fiber network is connected. After GoNetspeed completes the

installation of your Internet service, this light should be green and remain in that status.

If the light changes colors then check the fiber, power, and ethernet connections to the

ONT. If all the cables are connected properly and the problem persists, please open a

trouble ticket.

Need help?

Do you have a question about the GoNetspeed G-010G-A ONT and is the answer not in the manual?

GoNetspeed G-010G-A ONT Specifications

General

Describes the power light status (off, green, red) and initial troubleshooting steps.

Explains the PON light's function and troubleshooting for connection issues.

Details the alarm light status and when to open a trouble ticket.

Explains the data light's blinking pattern indicating network activity.

Identifies the PON port for fiber connection to the GoNetspeed network.

Describes the RJ45 Ethernet port for home network connection.

Details the reset button, power connector, and ON/OFF switch functions.

Illustrates how to mount the ONT using the wall bracket and align cables.