Goobay 93256 - Settings; Setting Time and Weekday; 12;24 h Display; Summer Time Function

13
5 Settings
5.1 Setting Time and Weekday
1. Press and hold the CLOCK button.
2. While holding the CLOCK button, also press the WEEK button
repeatedly until the correct day of the week is displayed.
3. While holding the CLOCK button, also press the HOUR button
repeatedly until the correct hour is displayed.
4. While holding the CLOCK button, also press the MINUTE button
until the correct minute is displayed.
5. Release all buttons.
Weekday and time are set.
5.2 12/24 h display
Press CLOCK and TIMER button simultaneously.
• The display changes between 12 and 24 h mode.
5.3 Summer time function
1. Press the CLOCK and ON/AUTO/OFF button simultaneously.
SUMMER is displayed.
Time is put forward by 1 hour.
2. Press both buttons again to change to winter time.
5.4 Programming switching times
A maximum of 10 switching time programmes are available.
These can be set in minimum 1-minute increments.
• Make sure that the set switching times do not overlap, especially if
you set up weekly programmes.
If switching times overlap, the timer performs the ON or OFF
function according to the programmed switching times.
  IfOFF(turno)andON(turnon)areprogrammed
  simultaneouslyby2dierentprogrammes,OFF(turno)willbe
executed.
Programming is only available in AUTO mode.
  
The display shows >> ON_1 <<.
2. Set the switch-on time of the 1st switching time programme using
the WEEK, HOUR and MINUTE buttons.
  
The display shows >> OFF_1 <<.
  󰀨
MINUTE button.
  
ting.
The display shows >> ON_2 <<.
6. Repeat steps 1. to 5. to program further switching times.
7. Press the CLOCK button to leave the program menu.
The time switch is now set up.