To Next PageTo Next Page
Need help?Do you have a question about the Goodman ComfortNet ASZC180601BB and is the answer not in the manual?
General| Brand | Goodman |
|---|---|
| Model Number | ASZC180601BB |
| Type | Heat Pump |
| Tonnage | 5 Ton |
| SEER | 16 |
| HSPF | Up to 9.5 |
| Refrigerant | R-410A |
| Voltage | 208/230 |
| Phase | 1 |
| Stages | 2 |
| ComfortBridge Technology | Yes |
| Cooling Capacity (BTU/h) | 60000 BTU/h |
| Heating Capacity (BTU/h) | 60000 BTU/h |
| Compressor Type | Two-Stage Scroll |
| Warranty | 10 Years |
ASXC, DSXC, GSXC Condensing Units, ASZC, DSZC, GSZC Heat Pumps with R-410A.
Critical warnings for safe refrigerant handling procedures.
Description of the cooling cycle and operation.
Diagram and explanation of the cooling cycle.
Chart for diagnosing cooling and heat pump issues.
Procedure for checking system voltage.
Diagnostic codes for PCBJA101/102 air handlers.
Diagnostic codes for PCBJA104 air handlers.
Procedure for checking time delay relays.
Motor checks and diagnostics.
Unitary diagnostic codes for PCBHR101-103/PBBGR101-102.
Unitary diagnostic codes for PCBHR104/PCBHR105.
Table of unitary diagnostic codes and their meanings.
Procedure for checking high pressure control.
Checking capacitor capacitance with a multimeter.
Performing electrical checks on low voltage control circuits.
Procedures for checking the motor.
Procedure for checking the compressor.
Procedure for testing compressor unloader operation.
Procedure for testing compressor operation.
Testing temperature sensors.
Procedure for checking compressor efficiency.
Procedure for checking wiring integrity.
Checking UC control compressor contactor/relay.
Diagnostics for Copeland Comfort Alert UC control.
Checking voltage at high/low pressure switches.
Checking Emerson Ultratech ECM motors.
Performing electrical checks on high voltage power circuits.
Checks for motor control and end bell components.
Adjusting CFM settings for AVPTC/MBVC ECM motors.
Procedure for testing compressor winding resistance.
Checking the reversing valve and solenoid.
Information on electronic blower/heater controls.
Troubleshooting compressor burnout.
Information on CTK0*** ComfortNet thermostat systems.
Checking high and low voltage to ECM motor.
Procedure for checking run capacitors.
Procedure for testing compressor ground faults.
Procedure for testing the defrost control.
Checking capacitor resistance with a multimeter.
