Need help?Do you have a question about the Goodman TSTATG2100-2 and is the answer not in the manual?
General| Brand | Goodman |
|---|---|
| Model | TSTATG2100-2 |
| Category | Thermostat |
| Language | English |
Mandatory step to disconnect power to HVAC system before thermostat installation or removal.
Advises replacing batteries every 12 months to ensure proper thermostat operation.
Describes the main display showing temperature and operational status.
Identifies buttons for temperature adjustment, mode selection, and fan control.
Explains the LED indicator for heat (Red) or cool (Green) demand.
Shows system status for heating or cooling operations, flashing when active.
Displays current room temperature and the desired set temperature.
Indicates when the thermostat's batteries are low and need replacement.
Confirms when the auxiliary heat function is energized.
Instructions for selecting Cool, Heat, or Off modes, and Auto/On fan settings.
How to use the cooler and warmer buttons to set the desired temperature.
Details on Emergency, Normal, and Lockout settings for auxiliary heat.
Procedure to set the thermostat display to degrees Celsius.
Procedure to revert the thermostat display to degrees Fahrenheit.
Lists essential tools like a flat blade screwdriver and wire cutter/stripper.
Ensures heat pump is working and power is turned off at the fuse panel.
Instructions on how to safely remove the old thermostat's front cover.
Steps to loosen screws and detach the thermostat base from the wall.
Safely disconnect wires, tape, and mark them for correct reinstallation.
Instructions to pull out and swing down the battery door.
Guide to remove old AA batteries and insert new alkaline ones.
Procedure to push up and snap the battery door closed.
Cross-references old thermostat terminal designations to new ones.
Explains the function of the insulating sheet and how to route wires through it.
Steps to confirm proper activation of the heating system.
Procedure to verify the auxiliary heat function engages correctly.
Explains how second-stage heating activates based on temperature differentials.
Steps to confirm proper activation of the cooling system.
Procedure to verify the fan runs continuously when set to 'On'.
Addresses issues with stiff slide switches and their potential cause.
Diagnoses common reasons for the air conditioning not turning on.
Provides solutions for when the fan fails to engage with the compressor.
Explains why Aux Heat might not activate and how to resolve the issue.
Diagnoses issues preventing the primary heating system from turning on.
Details the one-year warranty, coverage, and verification of installation date.
Excludes liability for incidental or consequential damages.
Outlines conditions that void the warranty, such as faulty installation.
To Next Page
