Troubleshooting5
Problem What to do
The projector
shuts down
automatically.
No signal on screen.
Connect the power adapter again
and make sure it is connected well.
Turn off the projector, and leave it to
cool down, then turn it on again in
about an hour.
Check whether the input signal
source of the projector is switched
to the existing signal source.
Check whether there is any problem
with the input signal cable.
Check again whether the external
signal source is output signal
normally.
The projector
can’t be powered
on.
Check whether the external power
supply(AC adapter) is connected
well.
Press the power button from the unit
to power on this unit. If not, please
press the power on button from the
unit to turn on.
The picture is
not clear.
Manually adjust the projector’s focus
dial to make the image clearer.
Check the projector lens isn't dusty.
To Next Page
Loading...