Need help?Do you have a question about the goodnature A24 and is the answer not in the manual?
General| Brand | goodnature |
|---|---|
| Model | A24 |
| Category | Computer Accessories |
| Language | English |
Follow installation and safety advice to set up your trap correctly for safe operation.
Contact Goodnature via email or phone for assistance with rodent control.
The Automatic Lure Pump (ALP) dispenses lure over 6 months to attract rats and mice.
The A24 uses a CO2 canister and trigger mechanism to humanely kill rodents.
After firing, the piston retracts, allowing the trap to reset for subsequent kills.
The Digital Strike Counter tracks the number of rodents killed before scavenging.
Small chew cards with toxin-free lure used as pre-feed to attract rodents.
Install Lure Tasters with the A24 to attract rodents, place them around the area.
Move traps weekly if unsuccessful to find rodent hotspots for better catch rates.
Select up to six locations around your property, about 20 ft apart, to install Lure Tasters.
Fold the Lure Taster card with the orange side facing out to release the lure.
Secure Lure Tasters 5 inches off the ground, allowing rodents access to the card.
Look for bite marks on Lure Tasters to identify safe feeding locations for trap placement.
Place traps in sheltered, hidden spots like roofs, garages, or kitchens for rodent safety.
Bite marks on Lure Tasters indicate a good location for installing your trap.
Move traps weekly to new spots if no catches occur to find rodent hotspots.
Finding the best location may take time; patience is key to successful rodent control.
Place traps in sheltered farm locations like buildings, near waterways, or hedges.
Store food securely and clear debris to reduce rodent hiding places and food sources.
Move traps if they are not catching anything to find effective locations.
Regularly check traps to ensure they are firing and baited, adjust network size if needed.
Share tips with neighbours to stay informed about and manage farm-wide rodent issues.
Unclip the orange Stand Lock by pressing the tab backwards.
Guide the trap's slot onto the stand's upper tab and ease it into the lower locking tab.
Secure the A24 to the stand by closing the orange Stand Lock until it clicks.
De-gas the trap first, then open the stand lock and pull the trap up.
Press the Black Tabs inwards and ease the Trap Mount off the Trap Body.
Screw the Trap Mount 5 inches above ground onto a tree or post, do not overtighten.
Tilt the trap backwards and lower it onto the mount's top locking tab until it clicks.
Ensure the trap is clicked in and the mount is securely screwed to the post.
Remove the gas canister cap and screw it firmly into the trap, hand-tightening only.
Wet the strap for lubrication and screw the Counter counter-clockwise onto the canister.
Press and hold the button to zero the Counter; press briefly to check the kill tally.
Push the trigger with a pen/twig to fire and retract the striker; keep hands clear.
Remove the coin from the ALP to activate lure dispensing for 6 months.
Shape the ALP into the Shroud Cap and align edges; wipe excess lure as pre-feed.
Place the Shroud Cap with ALP into the Lure Cradle and screw it in, then secure the cap.
Replace the Gas Canister and ALP every 6 months to ensure trap effectiveness and power.
Unscrew the gas canister (with a cloth) to deplete remaining gas; be careful of freezing.
Test-fire the trap by pushing the trigger until all gas is flushed out.
Squeeze black tabs and pull the trap upwards to detach it from the Trap Mount.
Declaration stating the product meets Machinery Directive requirements.
Important safety precautions, including using correct parts and handling the trap safely.
Warning that the lure contains allergens and is not for human consumption.
To Next Page
