1. Introduction
1. Introduction
This USB 3.0 SD card reader controller is based upon universal Serial Bus 3.0
specification, which integrates USB3.0 & USB2.0 Transceiver, MCU, SIE regulator and
memory card access units into a single chip. It can link in Super speed, High Speed, or
Full Speed operation and support USB2.0/USB3.0 power saving mode. Beside, this
also supports both the internal MCU program ROM, and external serial flash memory
interface. With the external serial flash memory interface, the firmware could be easily
updated through USB link.
This SD card reader integrate all regulator, clock generation circuitry and MOSFET
components for switching card power, and also dramatically reduce the system cost.
Package Contents
Before installation, please check the items of the package.
SD Card Reader x1
User Manual x1
System Requirements
Support full USB 3.0 speed at Windows
®
7, Windows Vista
®
, Windows
®
XP
3
To Next Page
Loading...