Need help?Do you have a question about the GOODWOOD AUDIO THE TX UNDERFACER and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Inputs | 2 x 1/4" TRS |
| Outputs | 2 x 1/4" TRS |
| Headphone Output | No |
| Phantom Power | No |
| Mounting | Pedalboard |
| Input Impedance | 1 MΩ |
| Power | 9V DC (center negative) |
| Output Impedance | 100 Ω |
Details the Underfacer's design for angled pedal boards and its role in professional audio setups.
Lists and briefly describes all input/output jacks, buttons, and LED indicators on the device.
Explains how to use the master mute for silent tuning, kill switch, or troubleshooting without FOH noise.
Details how to set the device to power up muted or un-muted via RMT switch and power connection.
Describes using stereo input for true stereo or dual mono output, useful for single or dual amp setups.
Details how to achieve dual mono signal for mono pedal boards using two amps via dip switch configuration.
Explains how to lift ground on the R output using the red button to prevent hum.
Details inverting the phase of the R output by 180° using the black button, requiring ground lift.
Specifies 9VDC power, center negative, with a minimum draw of 100mA.
Provides the width, depth, height, and weight for both the standard and TX versions.
To Next Page