2019 | Condential and Proprietary | Do not distribute
● Check Wi-Fi coverage with the camera
Hold the camera up where you are installing it, and view the
video stream with the Nest app.
If the camera can’t connect to Wi-Fi, or if the video stream is
interrupted, they might need to pick another location where
the signal is stronger. Even a few inches can make a
dierence.
● Secure the cable
Next, you’ll need to secure the power adapter and cable.
See below.
● Secure the power adapter and cable
Whichever way you mounted the camera, you’ll need to
aach the power adapter and cable to a wall or other suace
to keep it secure and to make it look tidy.
● Install the rst cable clip
Install the rst clip within 6 inches (15cm) of the camera. This
can help secure the camera’s position and prevent damage if it
ever gets knocked o of its magnetic mount.
To install each clip, we recommend drilling pilot holes
beforehand. Use a 3/32” (2 mm) bit for wood and similar
materials. Or, if you’re installing the wall anchors on brick or
stone, use a 7/32” (6 mm) masonry bit and then gently tap the
anchor into the hole with a hammer.
Inse the cable into the clip.
Screw the clip directly into the wall, or into the anchor.
Note: If you’re tightening the screw with a drill, be careful not to
drill into the cable itself. The cable should be fully inseed into
the clip, keeping it away it from the screw
To Next Page
Loading...