2D/3D Mode Switching
Installing/Removing Headband
08
The soft zero-sense headband is divided into forehead rest and soft
headband.
When installing, straighten the soft headband in the manner shown in
the figure "narrow at the top and wide at the bottom", tear off the
Velcro at both ends, pass through the buckles on both sides of the
forehead rest and stick it, and then insert the buckle of the forehead
rest into the socket on the top of the headset.
To disassemble, simply press the disassembly button on the inside of
the headset and pull up the headband.
- 34 - - 35 -
07
GOOVIS G3 Max supports Blu-ray 3D and Side by Side 3D format,
press the top 3D button to switch to 3D mode, and press the 3D
button again to switch back to 2D mode.
*Note: This function is used for special 3D film sources.
Install
Remove
In 3D mode, press and hold the 3D button for 3 seconds to perform
left and right screen swap*.
To Next Page
Loading...