Why GPX Motorcycle has weak sparks or no sparks at all?
If your GPX Motorcycle has weak or no sparks, it could be due to a faulty or dirty spark plug, a malfunctioning electronic ignition, or a faulty magneto. Remove the spark plug to test the spark.
What causes insufficient fuel flow in a GPX Motorcycle?
If your GPX Motorcycle has insufficient fuel flow, it could be due to an empty fuel tank, a blocked fuel pipe, or a blocked fuel tank cap vent. Disassemble the connection of the fuel pipe of the carburettor and check if the fuel pipe is blocked.
Why does my GPX 250r TSE have weak or intermittent sparks?
If your GPX Motorcycle has weak or intermittent sparks, it could be due to a faulty spark plug with carbon deposits, a malfunctioning electronic igniter, or a faulty magneto. Remove the spark plug and perform a spark test.
Why does GPX Motorcycle engine perform poorly at low speeds?
If your GPX Motorcycle engine performs poorly at low or idling speeds, it may be due to improper valve clearance adjustment, poor quality of rocker arm adjustment screws, or improper gas timing adjustment. Check valve timing, valve clearance, and gas timing adjustment.
What causes abnormal noise in GPX 250r TSE Motorcycle engine?
If your GPX Motorcycle engine has abnormal noise, it could be due to excessive valve clearance, valve wear, or piston and cylinder wear. Check whether there is abnormal noise in the valve or cylinder.
General| Final Drive | Chain |
|---|---|
| Front Tire | 110/70-17 |
| Rear Tire | 140/70-17 |
| Front Suspension | Telescopic fork |
| Front Brakes | Disc |
| Rear Brakes | Disc |
| Fuel Capacity | 14L |
Identifies key external parts of the TSE 250R motorcycle using numbered diagrams.
Locates VIN, Chassis, and Engine numbers on the motorcycle for registration and service.
Details physical dimensions, weight, tire sizes, engine parameters, and system specifications.
Explains the function and location of key controls like clutch, brakes, and throttle.
Provides guidance on safe riding, starting, stopping, turning, and general operation precautions.
Outlines recommended inspection intervals for various motorcycle components based on usage hours.
Explains how rider weight affects suspension settings and basic preload adjustment.
Details procedures for adjusting rebound and compression damping on front and rear shocks.
Provides instructions for removing and installing various motorcycle parts like forks, brakes, and bodywork.
Details procedures for inspecting, cleaning, and adjusting the drive chain and sprockets.
Covers inspection and maintenance of front/rear brakes, fluid levels, and pads.
Explains tire inspection, pressure checks, spoke checks, and wheel removal/installation.
Covers battery removal, changing, and the vehicle wiring diagram.
Details coolant level checks, draining, filling procedures, and radiator checks.
Introduces the engine's cooling system and general structure.
Covers engine installation, general maintenance, and specific adjustments like idle speed.
Details specifications, removal, and installation procedures for the engine's crankshaft and transmission.
Explains removal and installation of the magneto stator, rotor, and electric start gear components.
Lists torque values for various engine bolts and nuts for proper assembly.
Addresses common problems like engine not starting, poor performance, and abnormal noises with causes and solutions.
Provides diagnostic steps and solutions for issues related to brakes, clutch, gearbox, steering, and damping.
To Next Page
