- 4 -
Robot
Battery Installation
1. When replacing non-rechargeable batteries, only replace with the same battery type.
5. Do not mix new and old batteries or dierent types of batteries.
6. The battery should be installed in the correct polarity. Replace batteries according to
the diagram on the battery compartment.
7. Remove used batteries from toy.
8. The power terminal shall not be short-circuited.
9. Toy should not be connected to more power sources than recommended.
10. The batteries and charger must be checked whether its wires, plugs, casing and other
parts are damaged before use. If damaged, do not use until repaired.
Notes for battery usage:
1. The robot requires 3 x 1.5V AAA batteries (not included).
2. Firstly, open the battery box by hand by pulling on the
2 locking tabs on the side of the battery box.
3. Install 3x 1.5VAAA batteries according to the diagram.
4. Firmly close the battery cover, making sure the 2 locking
tabs on the sides have clicked into place.
Locking tabs
To Next Page
Loading...
General