GPX CR2307 User Manual

Customer Support: 1-888-999-4215 5
Plug the AC power cable into an AC power
outlet to power the clock radio.
1. Press and hold the TIME button.
2. While holding the TIME button, press
the HOUR button to adjust the hour
and the MINUTE button to adjust the
minute.
The PM indicator on the LED Display will
tell you if the time is set to PM. If there
is no PM indicator then the time is set to
AM.
1. Press and hold the ALARM button.
2. While holding the ALARM button,
press the HOUR button to adjust the
hour and the MINUTE button to adjust
the minute.
3. To wake to the buzzer, turn the volume
dial counter-clockwise to Buzzer until it
clicks into place. To wake to the radio
turn the volume to the desired level.
4. Adjust the OFF/ON/AL switch to AL to
activate the alarm.
1. Switch the OFF/ON/AL Toggle Switch
to the OFF or AL position.
2. Press and hold the SLEEP button.
3. While holding the SLEEP button, press
the HOUR button to increase the
hour and press the MINUTE button to
decrease the minute. The sleep timer
cannot be set for longer than 1 hour 59
minutes.
4. After the set amount of time has
expired the Radio will shut o.
Requires 1 9 volt battery (not included)
The backup battery is meant for short
unexpected losses of power. The clock radio
cannot fully function o of the backup
battery alone.
Setup and Clock
Power Setting the Clock
Setting the Alarm
Setting the Sleep Timer
Included

GPX CR2307 Specifications

Power

ac power	110V AC Line Cord built in
battery backup	uses one 9-Volt Battery (not included)
display size	1.2 inch

Weight and Dimensions

master carton dimensions	11.14L x 7.28W x 7.72H in
master carton weight	6.83 lbs
gift box dimensions	6.85L x 3.46W x 3.54H in
gift box weight	1.04 lbs
item dimensions	6.14L x 2.72W x 3.11H in
item weight	0.84 lbs
cuft	0.3623