Graco 4EVER DLX EXTEND2FIT - Page 109

109
Moving Lower Anchor Attachment
7
5. Push the LATCH
Connectors Out
Through the Desired
Belt Path Openings on
Each Side of Car Seat
Rear-Facing: Make sure the lower anchor strap is
in front of the buckle strap when the buckle is in the
inner-most position (A), and in behind when in the
outter-most position (B) and that it is flat and is not
twisted.
Forward-Facing: Make
sure the lower anchor
strap is routed behind
the harness strap, is
flat, and is not twisted.
Rear-
Facing
Forward-
Facing
2. Unsnap Bottom Seat Pad to Expose the LATCH
Strap
3. Pull Lower Anchor Connectors Out of the Belt
Path Openings into the Center of the Car Seat
4. Slide Entire Lower Anchor Strap Along Bar to
the Desired Belt Path Openings
Rear-Facing: Slide Lower anchor strap along bar to
the front of the seat.
Forward-Facing: Slide the Lower anchor strap up
along bar to the top.
A B
NWL0001153323A 4Ever DLX Extend2Fit USA ENG R07.indd 109NWL0001153323A 4Ever DLX Extend2Fit USA ENG R07.indd 109 8/28/20 3:50 PM8/28/20 3:50 PM