120
How to Lock Your Lap and Shoulder Vehicle Seat Belt
Note: With the vehicle seat belt in this locking mode,
all the tension is upwards in the shoulder belt. This
may start to tilt your car seat sideways. If this
happens, use a locking clip instead of this switching
the retractor. See Sliding Latch Plate and ELR
Retractor.
Note: When using the
lock-off, you do not need
to switch the retractor.
The lock-off locks the
seat belt.
Sliding Latch Plate and Switchable Retractor
A latchplate that slides freely on the belt webbing and
cannot, by itself, hold the belt snug around a car seat.
When installing the car seat, route the vehicle seat belt
through the proper belt path and buckle it in. Slowly
pull the shoulder belt all the way out to switch it
to locking mode. Then, as you pull the vehicle seat
belt tight, feed all the slack back into the retractor.
Grab the sides of the seat at the belt path and slide the
seat side-to-side and front-to-back. The seat should
not move more than 1” (2.5 cm).
NWL0001153323A 4Ever DLX Extend2Fit USA ENG R07.indd 120NWL0001153323A 4Ever DLX Extend2Fit USA ENG R07.indd 120 8/28/20 3:50 PM8/28/20 3:50 PM
To Next Page
Loading...
