Graco 4EVER DLX EXTEND2FIT - Page 123

123
Vehicle Information
10
Sliding Latch Plate and ELR Retractor
A latchplate that slides freely on the belt webbing
and cannot, by itself, hold the belt snug around a
car seat.
With this retractor, you will need to use a locking
clip to lock the vehicle seat belt.
To get a locking clip order online at gracobaby.com
or call 1-800-345-4109
Route the vehicle seat belt through the proper belt
path and buckle it in. Pull the vehicle seat belt tight.
While pushing down on seat, pinch the two straps
together behind the buckle tongue. Unbuckle the
belt without allowing it to slip.
Attach locking clip to lap and shoulder belts as
shown.
Rebuckle belt. Check that lap belt does not move
by pulling hard. If belt loosens or lengthens, repeat
procedure.
Note: When using the lock-off, you do not need
to use the locking clip. The lock-off locks the seat
belt.
Locking Clip
1” (2.5 cm)
NWL0001153323A 4Ever DLX Extend2Fit USA ENG R07.indd 123NWL0001153323A 4Ever DLX Extend2Fit USA ENG R07.indd 123 8/28/20 3:50 PM8/28/20 3:50 PM