35
Rear Facing
with Seat Belt
3-C
4. Place Car Seat Rear-Facing in Back Seat of
the Vehicle
Place rear-facing in vehicle seat and center the car
seat between the lower anchors. The base should
sit as flat as possible on the vehicle seat.
Note: Make Sure Base is a minimum of 80% on
Vehicle Seat.
5. Check the Level Indicator
Vehicle MUST be on level ground.
Check the level indicator on the car seat. The
bubble must be completely within the blue
zone.
If needed, rolled towels
may be placed under the
car seat at the vehicle
seat crease, until the
bubble is completely in
the blue area.
To Next Page