53
9. Attach Top Tether Strap
Extend the top tether by
lifting up on the tether lock
and attach.
Consult vehicle’s owner
manual for specific location.
10. Tighten Top Tether Strap
Remove all the slack.
11. Test For Tightness
Grab the sides of the seat where the
LATCH strap is and slide the car seat side-
to-side and front-to-back.
If the seat moves less than 1” (2.5 cm), it
is tight enough.
See section 6-A to secure your child.
LATCH can only be used if the vehicle
anchor spacing is 11” (28 cm) from the
center of one LATCH anchor to the center
of the other LATCH anchor.
Make sure that the red button faces away
from the car seat and the arrows are
pointing up. The InRight
TM
LATCH strap
should not be twisted.
8. Tighten the LATCH Strap
Press down firmly in the center of the car
seat while tightening the LATCH strap. You
may need to tighten through the slit in the
pad at the belt path as shown.
To Next Page
Loading...
