27
1. Place the infant restraint without base in a rear-facing
position in a vehicle seat.
2. Thread the lap belt or lap portion of a lap/shoulder belt under both
vehicle belt hooks:
3. Buckle the vehicle belt.
4. Tighten the vehicle seat belt.
To create a secure installation, push
down hard with your free hand on
the infant restraint Ì and pull and
tighten the vehicle belt.
5. Check infant restraint is level: Red level
line on the warning label MUST be
level with the ground .
6. Test infant restraint for secure
installation as described in infant
restraint “Final Safety Check” page 42.
Lap Belt
Ì
Lap/Shoulder
Belt
To Next Page
Loading...
Need help?
General