Graco Aire 4 XT User Manual

30
1. MAKE SURE vehicle is on level ground. Make sure to check your
vehicle owner's manual for LATCH seating
positions.
2. For ease of installation, press button to extend
LATCH to its MAXIMUM LENGTH
Ê
.
3. Position base in vehicle seat as shown.
4. Make sure LATCH is through vehicle/LATCH
belt path normally used for vehicle seat belt.
Ë
.
Belt must lie flat and not be twisted.
5. Attach connectors to vehicle lower anchors.
Pull firmly on connectors to be sure they
are attached Ì.
6. Tighten LATCH by pushing down hard on
base and pulling the adjustment belt back
through belt path .

Ë
6.3 Using LATCH to Install Base
Ê
Ì
CLICk!

Graco Aire 4 XT Specifications

General

Seat Capacity	1
Storage Basket	Large storage basket
Fold	One-hand fold
Weight Limit	50 lbs
Foldable	Yes
Car Seat Compatibility	Graco SnugRide 35, Graco SnugRide 30
Canopy	Yes
Harness	5-point
Wheel Type	Front swivel wheels
Harness Type	5-point
Recline Positions	Multiple
Compatible Car Seats	Graco SnugRide 35, Graco SnugRide 30
Weight	22 lbs