1. Infant restraint comes with four
(two on certain models) identical
canopy support parts.
Thread one canopy support
completely through one sewn
tunnel
.
2. Slide straight end of a second
support into the straight end of
the first support
.
3. On models with four canopy supports,
repeat steps one and two for the other
canopy tunnel. The canopy should appear
as shown
.
4. Attach canopy in the areas between the
infant restraint and the handle base
.
To remove the canopy, reverse the steps.
11
3.3 Attac hing Canop y
OR
To Next Page
Loading...
