OPERATIONS and ADJUSTMENTS
2
Buckle:
5-Point Models
• To buckle: Insert both tongues into
buckle. Pull up on tongues to be sure
they are locked.
• To unbuckle: Press red button and pull
tongues out of buckle.
Recline:
Recline - Rear-facing only
Semi-upright - Forward-facing only
Upright - Forward-facing only
To adjust: Pull recline handle out and rotate
car seat to desired position, then release
handle (fig. b).
Level Adjuster (Rear-facing only):
4 Positions to adjust to vehicle seat angle:
To adjust: Squeeze handle and rotate car seat
to position ball in green zone, then release
handle (fig. c).
IMPORTANT: Level adjuster must be in
position 1 when used forward-facing with
car seat in semi-upright or upright positions.
Harness Straps (fig. a):
• To tighten: Pull lower belt tab.
• To loosen: Pull and hold upper belt tab
while pulling harness straps.
Harness Tie:
• To open: Press tab and pull apart.
• To close: Snap halves together. Make
sure harness tie is locked by pulling out
on each half.
1
2
3
4
5
To Next Page
Loading...
