Graco Contour Electra - Page 13

13
Instructions
EN
To Set Up Pack ´N Play
See images
1
-
6
1. Lock the end rails by pulling them up, 2 opposite
sides at a time.
2. Push centre of oor down.
3. Install mattress, soft side up, and fasten with straps.
• To lock or unlock top rails, centre of oor must be UP.
• Rails will not lock when centre of oor is down.
• If top rails do not lock, centre may be too low.
To Cover Pack ’N Play
See images
12
-
13
Bassinet
(on certain models)
See images
14
-
29
Using The Electronics Module
(on certain models)
See images
30
-
37
Changing Table
(on certain models)
See images
38
-
46
Toy Bar
(on certain models)
See images
47
-
52
• Toy can vary depending on the model.
Features may vary depending on the
model
To Fold Pack ´N Play
See images
7
-
11
1. Remove mattress from the playard.
2. Pull centre of oor halfway up.
3. Pull up the end rails and push in the buttons, 2
opposite sides at a time, to unlock the rails.
4. Lower each rail.
5. Pull the centre of oor all the way up.
DO NOT FORCE FOLD!