CLICK!
9. Extend the EZ Tight™ UAS Strap
Press in and hold on the blue release
button on the EZ Tight™ UAS retractor and
pull the EZ Tight
TM
UAS strap until it is fully
extended.
10.
Attach Each EZ Tight
TM
UAS Connector
to Vehicle’s Lower UAS Anchors
EZ Tight
TM
UAS strap should lie flat and not
be twisted. If twisted, you will not be able to
tighten the EZ Tight™ UAS.
EZ Tight
TM
UAS can only be used if the
vehicle UAS anchor spacing is 28 cm
(11 inches) from the centre of one UAS
anchor to the centre of the other UAS
anchor.
To Next Page
Loading...
