2. Slide Entire EZ Tight™ UAS
Strap Along Bar to Correct Belt
Path Opening
Rear-Facing:
Slide EZ Tight
TM
UAS
strap down to the blue label.
Forward-Facing:
slide the EZ Tight
TM
UAS strap up to the orange label.
3. Feed the UAS Connector with the Adjuster Closest to it Through
the Chosen Belt Path
Rear-Facing: Make sure the EZ Tight™ UAS strap is in front of the buckle
strap when the buckle is in the inner-most position (A), and in behind when in
the outter-most position (B) and that it is flat and is not twisted.
BA
To Next Page
Loading...
