13
3.3 Removing and Attaching Base
3.4 Adjusting Handle
To remove infant restraint, squeeze handle at
back of seat and lift infant restraint from base
as shown
.
To put infant restraint in base, push infant
restraint down until it clicks into base. Pull up
on infant restraint to be sure it is latched
firmly into base.
1. Press handle adjustment buttons on
both sides of handle
.
2. Rotate handle until it clicks into any
of the 5 positions:
Position A: MUST be used
when carrying by handle,
Position B,C,D: are convenience
positions,
Position E: is the sitting position,
NEVER use positions B or C
in the vehicle.
BOTH handle adjustment
buttons must pop out to lock
handle in place
.
3. Push and pull on the handle
to be sure it is locked firmly
in position.
Carrying
Sitting
A
B
C
D
E
To Next Page
Loading...
Need help?
General