To Next Page

To Previous Page

6.1.1 3-Point Harness

1. From back, push harness anchor

buckle back through harness slot.

If necessary, from front, use harness

strap to pull buckle from slot

.

2. Reinsert harness anchor buckle in the

appropriate slot

.

3. From back, remove harness strap from

harness tightener. If necessary, from front,

use harness strap to pull strap from slot.

4. Reinsert strap in the appropriate slot. Thread

strap through tightener exactly as shown

.

5. SAFETY CHECK:

a) CHECK that straps are not twisted;

b) CHECK that straps are secure: pull on

harness straps from front.

c) CHECK that harness anchor buckle is

snapped flat against back as shown

.

Harness

tightener









Harness anchor

buckle

Graco Mosaic User Manual

Other manuals for Graco Mosaic