• This feature will allow you to locate a misplaced Parent Unit as long as the Parent Unit
is powered on and within range of the Nursery Unit.
• To activate, press the “PF” button on the front of the Nursery Unit (the Nursery Unit
needs to be ON).
• The Parent Unit will generate an audible beep every second and the SoundLights will flash on and off.
• Once the Parent Unit is located, the audible beep can be shut-off by pressing any button on the Parent
Unit.
Operation
To Listen To Baby
• Turn on Nursery Unit using the ON/OFF button.
• Turn on one or both Parent Units using the ON/OFF button.
• Adjust the volume on the Parent Unit by pressing the Volume Up/Down buttons.
Note that the Sound on the bars as the volume button is pressed up or down to
provide a visual feedback for the volume level. The unit will beep louder or softer
depending on the volume level.
• The SoundLights on the Parent Unit will illuminate as your child (or other objects)
make noise near the Nursery Unit. Please note that the SoundLights and volume
control on the Parent Unit are independent of each other. With the volume turned
all the way down, the SoundLights will still illuminate as your child (or other objects)
make noise near the Nursery Unit.
Parent Finder Feature
Vibration Alert Feature
1.To turn on the Vibration Alert Feature, press and release the button on the left
side of the LCD screen.
2. The icon will display on the LCD.
NightLight Feature
1.To turn on the NightLight on the Nursery Unit from the Parent Unit press the
NightLight Button. This will put the NightLight on the low setting and you will see
the low symbol .
2. To turn the NightLight on high setting press the NightLight Button one more time
and the high symbol will show.
3. Press NightLight Button again to turn off.
4. The NightLight can be turned on at the Nursery Unit also. Press the NightLight
Button on the top of the Nursery Unit once for low setting, twice for high setting
and a third time to turn it off.
54
It is VERY IMPORTANT to test the system when first set up, and at regular times thereafter.
Test the units if you suspect they may have been damaged or have not been used for a long time.
1. If two adults are present, have one take the Parent Units to different locations, trying various volume
settings, while the other speaks into the Nursery Unit.
2. If only one adult is available, place a ticking clock, radio, or other sound-producing device near the
Nursery Unit to test it.
3. When testing, keep the level of your child’s sounds in mind, and adjust the volume accordingly.
4. If there is sound interference, switch the Nursery Unit and the Parent Units to another channel
setting.
Testing the System
To Next Page
Loading...
