Graco SNUGRIDE 35 LITE LX - Page 37

3 Rear
Facing
37
7. Test For
Tightness
Grab the sides of the
base where the seat
belt is and push and
pull the base from
side to side and front
to back.
If the base moves
less than 1” (2.5
cm), it is tight
enough.
8. Attach Car Seat
to Base
Place car seat into
the base. Push down
on the front of the car
seat and handle until
you hear a “click”.
Test to make sure the
car seat is attached
by pulling up on the
front corners of car
seat.
CLICK!