Graco SNUGRIDE SNUGFIT TM 35 DLX - Install Without Base With Vehicle Seat Belt

3 Rear
Facing
42
3-D Install Without Base With
Vehicle Seat Belt
1. Place Car Seat in
Back Seat of the
Vehicle
Place the car seat
on the vehicle seat.
Push it back until the
front of the car seat
touches the vehicle
seat back.
Check the rear-facing
level line. The red
level line on the side
of the seat MUST
BE LEVEL with the
ground.
If needed, rolled
towels may be placed
under the base, at the
vehicle seat crease,
until the level line is
level with the ground.