Graco SNUGRIDE SNUGLOCK - Page 26

3 Rear
Facing
26
12. Attach Car Seat
to Base
Place car seat into the
base. Push down on
the front of the car seat
and handle until you
hear a “click”.
Test to make sure the
car seat is attached by
pulling up on the front
corners of car seat.
11. Test For Tightness
Grab the sides of the
base at the belt path,
push and pull the base
from side to side and
front to back.
If the base moves less
than 2.5 cm (1 in), it is
tight enough.
CLICK!