Graco SNUGRIDE SNUGLOCK - Page 33

3 Rear
Facing
33
9. Attach Car Seat
to Base
Place car seat into the
base. Push down on
the front of the car
seat and handle until
you hear a “click”.
Test to make sure the
car seat is attached by
pulling up on the front
corners of car seat.
8. Test For Tightness
Grab the sides of the
base where the seat
belt is and push and
pull the base from side
to side and front to
back.
If the base moves less
than 2.5 cm (1 in), it is
tight enough.
CLICK!