EasyManua.ls Logo

Graco TRAILRIDER - Product Setup; Product Use

Graco TRAILRIDER
57 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9 10
To Secure Child - 5 Point
Harness
See images

-

To avoid serious injury from falling or
sliding out, always secure your child
with harness.
DO NOT cross the shoulder belts. This
will cause pressure on child’s neck.
Make sure the harness is adjusted
properly and your child is snugly
secured. The space between the child
and the shoulder harness should be
about the thickness of one nger.
To Adjust Shoulder
Harness Position
See images


In order to protect your child from
falling out, after your child is placed
into the seat, check whether the
shoulder and waist harnesses are at
proper height and length.
To Use Canopy
See images


To Recline Backrest
See images


To Use Brake
See images


Always apply brake when stroller is in
stopped position.
Hand brake is not intended as a parking
brake.
To Adjustable Rear
Wheel Suspension
See images


The suspension is soft as

The suspension is hard as

Please ensure there is no weight placed
on the stroller when you are adjusting
the rear suspension.
To Use Front Swivel Lock
See images


It is recommended to use swivel locks
on uneven surfaces.
To Fold Stroller
See images

-

Please fold the hood before folding the
stroller.
To Use Rain Cover
See image

Before using the rain cover, please
make sure the backrest has been
adjusted to the lowest position and the
infant child restraint has been fastened.
When using the rain cover, please
always check its ventilation.
When not in use, please check that the
rain cover has been cleaned and dried
before folding.
Do not fold the stroller after assembling
the rain cover.
Do not place your child into the stroller
assembled with rain cover during hot
weather.
To Attach and Remove
Graco® Click Connect™
Infant Car Seat(8AG/ 8AV/
8AO) (May Not Be Included)
See images

-

This stroller is only compatible with Graco®
SnugRide® infant car seats with Click
Connect™. Only use with Graco® infant car
seats that have the Click Connect™ logo.
Improper use of this product with a car
seat may result in serious injury or death.
Read the manual provided with your
Graco car seat before using it with your
product.
Always secure your child with the car
seat harness when using the car seat in
the stroller. If your child is already in the
car seat, check that the child is secured
with the harness.
DO NOT use stroller for jogging while
carrier is in stroller.
Product Set Up
Please read all the instructions in this
manual before assembling and using this
product.
To Open Stroller
See images
-
Check the stroller frame is completely
latched open before continuing.
Rear Wheels
See images
-
To Set Up Canopy
See images
-

To Attach and Remove
Armbar
See images

-

The completely assembled stroller is shown
as

Product Use
To Adjust Handle
See images


Handle can be adjusted to 5 positions.
To Adjust Calf Support
See image

The calf support has 2 positions.
Raise Calf Support
To raise the calf support, just lift it upwards.
Lower Calf Support
Press the adjust buttons on both sides of
the calf support

- 1, and rotate the calf
support downwards.

- 2

Other manuals for Graco TRAILRIDER

Related product manuals