73
Using Belt Positioning Clip
1. Make Sure Vehicle’s Seat Shoulder Belt Lays in the
Red Zone As Shown
If the vehicle’s seat shoulder belt lays outside this zone,
you MUST use the belt positioning clip.
2. Attach Belt Positioning Clip
The shoulder belt positioning
clip MUST be attached to
the slot on the bottom of the
base. Insert the loop end
of strap through the slot on
bottom of seat exactly where
shown.
3. Push Clip and Strap Through Loop
Pass the clip and the strap through the loop end as
shown and pull strap up.
To Next Page
Loading...
