83
How to Lock Your Lap and Shoulder Vehicle Seat Belt
Sliding Latch Plate and Switchable Retractor
A latchplate that slides freely on the belt webbing and cannot,
by itself, hold the belt snug around a car seat.
When installing the car seat, route the vehicle seat belt through
the proper belt path and buckle it in. Slowly pull the shoulder
belt all the way out to switch it to locking mode. Then, as
you pull the vehicle seat belt tight, feed all the slack back into
the retractor.
Grab the sides of the seat at the belt path and slide the seat
side-to-side and front-to-back. The seat should not move more
than 1” (2.5 cm).
To Next Page
Loading...
