85
Sliding Latch Plate and ALR Retractor
A latchplate that slides freely on the belt webbing and
cannot, by itself, hold the belt snug around a car seat.
Slowly pull the shoulder belt all the way out. Route the
vehicle seat belt through the proper belt path and buckle
it in. Then, as you pull the vehicle seat belt tight, feed all
the slack back into the retractor.
Grab the sides of the seat at the belt path and slide the
seat side-to-side and front-to-back. The seat should not
move more than 1in (2.5 cm).
To Next Page
Loading...
