EasyManua.ls Logo

Graco Ultra Clear 2L01VIB - Troubleshooting

Graco Ultra Clear 2L01VIB
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Most problems have a simple
solution. First, check that:
• Power is turned ON for both units
• Both units are plugged in (or batteries are
fresh in Parent Unit)
• Electrical outlet works
• Volume is turned up on Parent Unit
• Parent Unit is in range of the Nursery Unit
No Sound
• Battery dead or weak — replace or use AC
adapter.
• AC adapter not properly connected —
check the connections.
• Nursery Unit covered or blocked —
remove the obstruction.
Weak Sound
• Nursery Unit too far from baby — move
closer.
• Large objects blocking the signal — try
repositioning Nursery Unit.
• Volume setting too low — turn it up.
DO NOT ATTEMPT to modify the unit. Any modifications to the transmitter
and/or receiver can void the operator’s authority to operate the equipment.
Static
• Interference from other electrical
equipment — eliminate cause of static
(TVs, mixers, computers, fans, fluorescent
lights, light dimmers, etc.)
• Parent Unit too far from Nursery Unit —
move them closer.
• Significant amount of obstructions
between Parent Unit and Nursery Unit such
as walls, ceilings & buildings. Try moving
the Nursery Unit to another part of the
room.
• Change channel on Nursery Unit.
Shrill Sound (Feedback)
• Nursery Unit and Parent Unit too close
together — move them farther apart.
• Volume set too high — lower the volume.
TroubleShooting
6

Related product manuals