Need help?Do you have a question about the grado GW100 and is the answer not in the manual?
General| Wireless | Yes |
|---|---|
| Bluetooth Version | 4.2 |
| Battery Life | 15 hours |
| Driver Size | 40 mm |
| Frequency Response | 20Hz - 20kHz |
| Nominal Impedance | 32 ohms |
| Driver Type | Dynamic |
| Sensitivity | 99.8 dB |
| Connector | 3.5 mm |
| Type | Open-back |
Button used for powering the device on/off and performing actions.
Button to increase audio volume or perform actions.
Button to decrease audio volume or perform actions.
LED that shows charging status and battery level.
Auxiliary input for wired audio connection.
Integrated mic for calls and voice commands.
Micro USB port for charging the device.
Detailed instructions for turning the device on and off using the power button.
Information on the battery saver feature that powers off the device when idle.
Explanation of LED indicators for charging, fully charged, and low battery states.
Instructions on how to charge the GW100 using the provided cable and a USB port.
Steps to activate pairing mode by holding the power button until lights flash.
Guide on finding 'Grado GW100' in device settings and tapping to pair.
How the device connects to a second device when the first is out of range or off.
Using the power button for short press to play or pause music.
Using volume buttons for short press to increase/decrease volume.
Using volume buttons for long press to skip to the next/previous song.
Short press to answer/hang up, long press to reject calls.
Double pressing the power button to launch the voice assistant.
To Next Page