Graef WK 403 - Unpacking; Installation Location Requirements; Before First Use

15
DE
EN
FR
NL
PL
DK
NO
SE
PYC
water only.
● The lid of the unit must always be rmly closed.
● Make sure the unit is switched off and is not connected to the
mains.
● Do not use any aggressive or abrasive cleaning agents and do not
use any solvents.
● Do not scratch off stubborn soiling with hard objects.
● Do not rinse the unit off in water or immerse it into water.
UNPACKING
To unpack the unit, proceed as below:
● Take the unit out of the carton.
● Remove all pieces of the packing.
● Remove any possibly extant labels on the unit (do not remove the rating label).
REQUIREMENTS FOR THE INSTALLATION LOCATION
For safe and awless operation of the unit, the place of location must meet these
prerequisites:
● The unit must be set up on a rm, at, level and non-slip base that has sufcient
load bearing capacity.
● Make sure the unit cannot fall over.
● Select the location so that children cannot reach the hot surfaces of the unit and
cannot touch the cable.
BEFORE THE FIRST USE
Read these operating instructions thoroughly and keep them handy for referral
later on.
This unit brings water to boil in a few minutes.
● To clean the unit, rst ll the unit with clear, cold water and then boil it. Subse-
quently pour away the water because of hygenical reasons.