2. Service level
4 / 8
The number can be increased (+1) starting with the last digit of the seconds display using the arrow
key. The number can be decreased (-1) starting with the last digit of the seconds display using the
arrow key. The number is stored using the button. The seconds are set analogous to the minutes. The
number is stored using the button. The display then jumps from the menu back to the “Number of
cycles” display.
2.5 Perform cycle restart
From the menu point “Starting times” press the arrow key. “Cycle restart” appears on the screen.
Press the button. The following appears on the screen:
Pressing the button restarts the programme with the current settings.
All users are disabled once the cycle reset is activated. The control system goes directly to cycle pause
(T13/T14). A new cleaning cycle starts when the next starting time begins.
2.6 Clear logbook
From the menu point “Operating hours” press the arrow key. “Clear logbook” appears on the screen.
Press the button. The following appears on the screen:
Pressing the button will delete all fault messages and all operating hours. “OK” is displayed on the
screen whilst the control system performs the deletion. The screen then jumps to the display “Empty log-
book”.
All current operating hour meters, cycle meters and the logbook are deleted.
2.7 Select language
From the menu point “Clear logbook” press the arrow key. “Languages” appears on the screen. Press
the button. The following appears on the screen:
English
Press the ^
Press the ^
To Next Page
