SETUP
1. Remove frame and back from box.
2. Place frame on side on a working surface.
3. Attach the leg extensions to the transfer bench, if not attached already.
Depress the buttons and slide the legs onto the frame until the buttons
protrude fully from the desired holes.
ATTACHING THE BACKREST (IF NOT ATTACHED ALREADY)
1. Determine the side on which the backrest should be mounted by knowing
which direction the user will face when sitting on the bench in the tub.
2. Position the bench upright on a level surface.
3. Locate the channel guides (4 each) on underside of seat. Align
backrest support tubes with channel guides in position appropriate to
step 1.
4. Slide backrest seat support tubes through channel guides until seat
support tube push buttons protrude fully through channel guide holes.
CAUTION: Backrest is not designed to support the full weight of the user.
ADJUSTING LEG HEIGHT
1. Depress the height adjustment button and slide the lower leg upward
or downward until the height adjustment button clicks into place in the
desired hole.
2. Repeat for other 3 legs.
CAUTION: Ensure that all four legs are adjusted to the same height.
USING YOUR TRANSFER BENCH
NOTE: Be sure to move slowly throughout use to prevent injuries.
NOTE: Children or those who need assistance should NOT be left
unattended during use of this product.
From a seated position (such as a wheelchair):
1. Place your wheelchair next to the bench, facing the front of the bathtub.
2. Engage wheelchair locks.
3. Transfer your torso to the transfer bench rst, and then lift your legs
into the tub. Move slowly to prevent injuries.
4. After bathing, lift your legs out of the tub rst, then your torso.
To Next Page
Loading...
Need help?
General