Graham Field Lumex LF1031

Questions and Answers

J
Jenna BrownAug 5, 2025
What to do if the control box is not responding and the relay is not clicking on my Graham Field Lumex LF1031 Lifting Systems?
- E
  Elizabeth JonesAug 5, 2025
  If the control box of your Graham Field Lifting System isn't responding and the relay isn't clicking, it might be due to several reasons: * The battery may be discharged: in this case you should charge the battery. * The battery charger itself could be defective: you should replace the battery charger. * The battery might be defective: consider replacing the battery. * The hand control pendant could be the source of the problem: replace the hand control pendant.
C
chanjamesAug 15, 2025
Why does the actuator/motor of my Graham Field Lumex LF1031 only go up or down, but not both?
- L
  Lisa QuinnAug 15, 2025
  If your Graham Field Lifting System's actuator/motor only moves in one direction (up or down), the issue might stem from: * A defective hand control pendant: the solution is to replace the hand control pendant. * A defective control box: in this case, replace the control box.
K
Kimberly IbarraAug 25, 2025
What to do if the actuator / motor does not run, but relay is clicking on Graham Field Lifting Systems?
- J
  Jennifer Terrell PhDAug 25, 2025
  If the actuator/motor of your Graham Field Lifting System doesn't run, but the relay is clicking, consider these potential causes: * The actuator plug may not be properly seated. Ensure it's firmly pushed into the control box. * The actuator could be defective, requiring replacement. * The control box might be defective, also requiring replacement.