FIREPLACE MOUNT:
Your Grain Comfort should be pulled from the masonry fireplace and cleaned from behind and
around it. This should be done prior to the heating season in conjunction with the chimney
maintenance.
The seal between the fireplace masonry and the unit, as well as the seals on the unit itself, should
be checked and resealed if there is evidence of leakage. Check gaskets around the door. Reseal
with new gasket if needed.
Lubricate the Blower Fans. (See page 22).
CLEANING:
The unit should not be cleaned with any type of harsh detergent especially on the door and glass.
Use soft cloth with gentle soapy water.
GLASS: The Grain Comfort Plus has a unique glass cleaning feature, however when burning
Wheat, Rye, or Corn and on occasion wood pellets, the glass may cloud up. After the fire is out
and glass has cooled, the glass may be cleaned with a soft cloth and a water based glass cleaner.
Check the gasket around the glass for air leaks. Replace immediately, if leaks are found. Heat
from the fire will not break the glass. The glass door should be handled as any other breakable
glass, as rough handling, etc. may cause damage.
If repainting or touch-up is required the unit should be lightly sanded with fine sand paper or
steel wool, then repainted or touched up with high temperature flat black paint or the colour of
the stove. (Available from your Dealer or Grain Stoves Inc.)
If the unit is located in a damp location, check thoroughly for signs of condensation when the
unit is not in use. Leave the Door Open if you are not going to use the Stove for a while. This
will prevent condensation from building up.
When the heating season is over, the unit can be cleaned out completely with a wire brush or fine
steel wool to remove ash stuck to walls. The unit should be vacuumed out.
23
To Next Page
Loading...