765042402 Rev. 000 40
Models with solid door:
Fig.8
Models with glass door:
The door should only be reversed by a properly skilled service technician with knowledge
of the product.
The light in the glass door, can be switched to work in two different ways.
Light constantly on (Lco) or light off when door closed (Ldo).
Push and hold for 5 seconds to change between Lco and Ldo.
Insufficient cleaning will cause that the product will not work at optimum performance, or
eventually it will be defective.
Before cleaning, the product should always be disconnected.
Do not flush the product with water, do not use water jet or steam hose
as this may cause short-circuits in the electrical system.
Cleansing agents containing chlorine or compounds of chlorine as well
as other corrosive means, are not to be used, as they might cause
corrosion to the cabinet and the refrigeration system.
1. Switch off the power at the mains socket.
2. Open the door
3. Dismantle the two screws that hold the control panel at the front and loosen the two
screws the hold the tabletop in the back, pull the complete tabletop a little forward,
and then tilt it upwards.
4. Dismantle the hinge in pos. A, and lift off the door.
5. Dismantle the hinge in pos. B, and mount it in pos. D.
6. Turn the door 180°, and fit it to the hinge in pos. D.
7. Mount the hinge from pos. A in pos. C, and move the bracket from pos. C to pos. A.
8. Re-position and fasten the tabletop.
9. Apply power to the cabinet again.
To Next Page
Loading...
Need help?
General
